How can I make my nissan 350z stock woofer to stop rattling?

goldarm8 · Post by **goldarm8** » Sat Nov 17, 2007 12:42 am

It rattles against the cover to much and it doesn't sound very good. Does anyone know hoe to take that cover off or is ther anything i could use to stop the rattling? Thank you.

HEY YAH · Post by **HEY YAH** » Sat Nov 17, 2007 12:53 am

you need to put the bass down a little or get a better subwoofer meaning a new box and woof and amp.

Ian F · Post by **Ian F** » Sat Nov 17, 2007 1:02 am

Figure out what's rattling, and tighten it, or cover it in rubber or silicone.

This is assuming the "rattling" isn't actually distortion. In that case you'll need a stereo system that can put out high volume at higher quality, or speakers that can handle it..

John Paul · Post by **John Paul** » Sat Nov 17, 2007 3:38 am

The whole square plastic cover pulls off 6 clips straight toward the front. then you can replace the speaker with something a little better but keep in mind the BOSE speaker might be 8 ohms. A 12" should bolt right in. Also throw in some 6" fibreglass Non foil insulation.